2015 Jeep Grand Cherokee Owner Manual SRT - Page 252

250 UNDERSTANDING THE FEATURES OF YOUR VEHICLE 2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the HomeLink® button you wish to program while keeping the HomeLink® indicator light in view. 3. Continue to push and hold the HomeLink® button, while you push and release ("cycle") your hand-held transmitter every two seconds until HomeLink® has If you unplugged the garage door opener/device for successfully accepted the frequency signal. The indi- programming, plug it back in at this time. cator light will flash slowly and then rapidly when Reprogramming A Single HomeLink® Button fully trained. (Canadian/Gate Operator) 4. Watch for the HomeLink® indicator to change flash To reprogram a channel that has been previously trained, rates. When it changes, it is programmed. It may take follow these steps: up to 30 seconds or longer in rare cases. The garage door may open and close while you are programming. 1. Cycle the ignition to the ON/RUN position. 5. Push and hold the programmed HomeLink® button 2. Push and hold the desired HomeLink® button until the indicator light begins to flash after 20 seconds. Do and observe the indicator light. not release the button. • If the indicator light stays on constantly, programming is complete and the garage door/device should activate when the HomeLink® button is pushed. • To program the two remaining HomeLink® buttons, repeat each step for each remaining button. DO NOT erase the channels.