2015 Jeep Grand Cherokee Owner Manual SRT - Page 556

554 MAINTAINING YOUR VEHICLE Installing The Rear Wiper Adding Washer Fluid 1. Lift the rear wiper arm pivot cap away from the glass This vehicle is equipped with a Driver Information Display to allow the rear wiper blade to be raised off of the (DID), the DID will indicate when the washer fluid level is low. When the sensor detects a low fluid level, the windglass. shield will light on the vehicle graphic outline and the NOTE: The rear wiper arm cannot be fully raised off the "WASHER FLUID LOW" message will be displayed. glass unless the wiper arm pivot cap is unsnapped first. Attempting to fully raise the rear wiper arm without The fluid reservoir for the windshield washers and the unsnapping the wiper arm pivot cap may damage the rear window washer is shared. The fluid reservoir is located in the engine compartment, be sure to check the vehicle. fluid level at regular intervals. Fill the reservoir with 2. Lift the rear wiper arm fully off the glass. windshield washer solvent only (not radiator antifreeze). 3. Insert the wiper blade pivot pin into the opening on When refilling the washer fluid reservoir, take some the end of the wiper arm. Grab the bottom end of the washer fluid and apply it to a cloth or towel and wipe wiper arm with one hand, and press the wiper blade clean the wiper blades, this will help blade performance. To prevent freeze-up of your windshield washer system flush with the wiper arm until it snaps into place. in cold weather, select a solution or mixture that meets or 4. Lower the wiper blade onto the glass and snap the exceeds the temperature range of your climate. This wiper arm pivot cap back into place. rating information can be found on most washer fluid containers.