2015 Jeep Grand Cherokee Owner Manual SRT - Page 251

UNDERSTANDING THE FEATURES OF YOUR VEHICLE 249 • To program the two remaining HomeLink® buttons, Canadian/Gate Operator Programming repeat each step for each remaining button. DO NOT For programming transmitters in Canada/United States erase the channels. that require the transmitter signals to "time-out" after several seconds of transmission. Reprogramming A Single HomeLink® Button (Non-Rolling Code) Canadian radio frequency laws require transmitter sigTo reprogram a channel that has been previously trained, nals to time-out (or quit) after several seconds of transmission - which may not be long enough for HomeLink® follow these steps: to pick up the signal during programming. Similar to this 1. Cycle the ignition to the ON/RUN position. Canadian law, some U.S. gate operators are designed to 2. Push and hold the desired HomeLink® button until time-out in the same manner. the indicator light begins to flash after 20 seconds. Do It may be helpful to unplug the device during the cycling not release the button. process to prevent possible overheating of the garage 3. Without releasing the button proceed with "Program- door or gate motor. ming A Non-Rolling Code" step 2 and follow all 1. Cycle the ignition to the ON/RUN position. remaining steps. 3