1996 Mercury Sable Owner's Manual - Page 201

Follow the steps below to set these buttons to the desired frequencies: 1. 2. Select a band, then select a frequency. Press one of the memory buttons and hold the button until the sound returns. That station is now held in memory on that button. Follow the two steps above for each station memory preset button you want to set. With Radio set, you can automatically set strong stations into your memory buttons. AM, FM1 and FM2 will be set sequentially. Turn the radio off with the "VOL PUSH ON" knob. Press and hold the "SCAN" button and turn the radio on by pressing the "VOL PUSH ON" knob. Continue holding the "SCAN" button until "RAD" is shown in the display. NOTE: If there are less than six strong stations in the frequency band, the remaining unfilled buttons will store the last strong station detected on the band. After all stations have been filled, the radio will begin playing the station stored on memory button 1. Adjusting the tone balance and speaker output of your radio 3. u Using the Radio Set feature u Increasing or decreasing bass response Press the right (a) side of the "BASS" button to increase bass (more "lows"); press the left (b) side of the "BASS" button to decrease bass (less "lows"). 174