1997 Nissan Pathfinder Owner's Manual - Page 151

mission models, move the lever to "P"). Switch off all unnecessary electrical systems (light, heater, air conditioner, etc.). 3. Remove vent caps on the battery (if so equipped). Cover the battery with an old cloth to reduce explosion hazard. 4. Connect jumper cables in the sequence as illustrated. Do not keep starter motor engaged for more than 10 seconds. If the engine does not start right away, turn the key off and wait 3 to 4 seconds before trying again. 7. After starting your engine, carefully disconnect the negative cable and then the positive cable. 8. Replace the vent caps (if so equipped). Be sure to dispose of the cloth used to cover the vent holes as it may be contaminated with corrosive acid. SCE0149 ¼ Always connect positive (+) to positive (+) and negative (−) to body ground, engine lift bracket, etc. (not to the battery). ¼ Make sure that cables do not touch any moving parts in the engine compartment and that clamps do not contact any other metal. 5. Start the engine of the other vehicle and let it run for a few minutes. 6. Keep the engine speed of the other vehicle at about 2,000 rpm, and start your engine in the normal manner. Always follow the instructions below exactly. Failure to do so could result in damage to the charging system and cause personal injury. 1. Position the two vehicles to bring their batteries into close proximity to each other if the booster battery is in another vehicle. Do not allow the two vehicles to touch. 2. Apply parking brakes. Move the shift lever to "Neutral position" (On automatic trans- 5-8