1997 Nissan Pathfinder Owner's Manual - Page 78
1997 Nissan Pathfinder Manual
Page 78 highlights
in a sudden stop or collision. When you install a child restraint in a rear outboard seat, follow these steps: 1. Position the child restraint on the seat. It can be placed in a front facing or rear facing direction, depending on the size of the child. Always follow the restraint manufacturer's instructions. 2. Route the seat belt tongue through the child restraint and insert it into the buckle until you hear and feel the latch engage. Be sure to follow the child restraint manufacturer's instructions for belt routing. 3. Pull on the shoulder belt until all of the belt is fully extended and a click is heard. At this time, the belt retractor is in the automatic locking mode (child restraint mode). It will revert back to "emergency locking" when the belt is fully retracted. 4. Allow the belt to retract. A clicking sound will be heard as the belt retracts. This indicates that the retractor is in the automatic locking mode. Pull up on the belt to remove any slack in the belt. PD1174 PD1331 Installation on rear outboard seating positions ¼ The 3-point belt on your vehicle is equipped with a locking mode retractor which must be used when installing a child restraint. ¼ Failure to do so will result in the child restraint not being properly secured. It could tip over or otherwise be unsecured and cause injury to the child 2-37