1997 Nissan Pathfinder Owner's Manual - Page 39
1997 Nissan Pathfinder Manual
Page 39 highlights
flashes rapidly for 1 to 2 seconds, then remains on, your garage door opener has a rolling code system. To operate your "Rolling Code" garage door opener from your HomeLink Transmitter, follow these steps: 1. Program your hand held transmitter to the HomeLink Transmitter by following the procedures outlined above (if not yet programmed). 2. Program your garage door opener receiver to recognize your HomeLink Transmitter (The HomeLink Transmitter follows the same procedure to train to the receiver as your hand held transmitter did when it was first installed): a) Remove the cover panel from your garage door opener receiver. The receiver should be located by the garage door opener motor. b) Locate the training button on the garage door opener receiver. The exact location and color of the button may vary by garage door opener brand. If you have difficulty locating the training button, reference your garage door opener manual. If you have difficulty programming your garage door opener equipped with a rolling code system to recognize the HomeLink Transmitter with the "Rolling Code" feature, call NISSAN Consumer Affairs Department. c) Press the training button on the garage door opener receiver for 1 to 2 seconds. d) Return to the HomeLink Transmitter in the vehicle, and depress the programmed HomeLink button for the duration of the fast blink on the HomeLink Transmitter (1 to 2 seconds). Release the button, and re-press to confirm that the system has trained. e) Your garage door opener should now recognize your HomeLink Transmitter. You may use either your HomeLink Transmitter or your original hand held transmitter to open your garage door. SPA0609 ROLLING CODES (If so equipped) If your hand held transmitter appears to train to the HomeLink Transmitter, but does not open your garage door, and your garage door opener was manufactured after 1995, your garage door opener may have a "Code Protected" or "Rolling Code" feature. This type of system will change the "code" of your garage door opener every time you open or close your garage door. To determine if you have one of these systems, depress the button on the HomeLink Transmitter that you have just programmed. If the LED on the HomeLink Transmitter CLEARING THE PROGRAMMING INFORMATION Should you sell your vehicle, be sure to clear the channels of the Integrated HomeLink Transmitter. To clear the channels, simultaneously hold down the outside two buttons (#1 & #3) until the red indicator light begins to flash rapidly (approximately 20 seconds). This will clear all three buttons. Individual buttons cannot be cleared, but can be reprogrammed at 1-34