2010 Nissan Murano Owner's Manual - Page 212
2010 Nissan Murano Manual
Page 212 highlights
Adjusting sound quality: Push the Audio control knob to change the selecting mode as follows. Bass ? Treble ? Fade ? Balance ? Beep Rotate the Audio control knob to adjust Bass, Treble, Fade and Balance to the desired level. Fade adjusts the sound level between the front and rear speakers and Balance adjusts the sound between the right and left speakers. To turn the beep sound off or on, rotate the Audio control knob until the desired mode is displayed. This turns on or off the beep sound when audio buttons are pushed. Once you have adjusted the sound quality to the desired level, push the Audio control knob repeatedly until the radio or CD display reappears. Otherwise, the radio or CD display will automatically reappear after about 5 seconds. CLOCK adjust: Push the CLOCK adjust button for more than 1.5 seconds to turn on the CLOCK display. See "CLOCK" in the "2. Instruments and controls" section for the detailed clock adjustment operation. AM-FM radio operation radio (FM/AM) band select: Pushing the radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station/channel played will also come on when the ON·OFF/VOL control knob is pushed to ON. If another audio source is playing when the radio band select button is turned to ON, the audio source will automatically be turned off and the last radio station played will come on. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): Turn the TUNE/FOLDER knob for manual tuning. SEEK tuning: or Push the SEEK·CAT or TRACK button to tune from low to high or high to low frequencies and to stop at the next broadcasting station. SCAN tuning: Push the SCAN tuning button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. 1 * to 6 * Station memory operations: Twelve stations/channels can be set for the FM band (6 for FM1, 6 for FM2) and 6 stations can be set for the AM band. 1. Choose the radio band AM, FM1 or FM2 using the radio band select button. 2. Tune to the desired station using the SEEK, SCAN or TUNE button. 3. Select the desired station/channel and keep pushing any of the desired station preset 4-40 Monitor, heater, air conditioner, audio, phone and voice recognition systems