2010 Nissan Murano Owner's Manual - Page 218
2010 Nissan Murano Manual
Page 218 highlights
low frequencies and to stop at the next broadcasting station. . For XM satellite radio Push the SEEK·CAT or TRACK button or to tune to the first channel of the next or previous category. During satellite radio reception, the following notices will be displayed under certain conditions...NO SIGNAL (No signal is received while the SAT tuner is connected.) OFF AIR (Broadcasting signed off) ANTENNA ERROR (Antenna connection error) LOADING (When the initial setting is performed) UPDATING (When the satellite radio subscription is not active) INVALID CH (Invalid channel is received.) SCAN tuning: Push the SCAN tuning button to tune from low to high frequencies and stops at each broadcasting station for 5 seconds. Pushing the button again during this 5 seconds period will stop SCAN tuning and the radio will remain tuned to that station. If the SCAN tuning button is not pushed within 5 seconds, SCAN tuning moves to the next station. 1 * Text: When the "Text" key is selected with the multifunction controller on the display and then the ENTER button is pushed while the satellite radio is being played, the text information will be displayed on the screen...CH Name Category Name Title Other to 6 * Station memory operations: Twelve stations/channels can be set for the FM band (6 for FM1, 6 for FM2) and the SAT radio (6 for SAT1, 6 for SAT2), and 6 stations can be set for the AM band. 1. Choose the radio band using the radio band select button. 2. Tune to the desired station using the SEEK, SCAN or TUNE button. 3. Select the desired station/channel and keep pushing any of the desired station preset 1 6 buttons * to * until a beep sound is heard. (The radio mutes when the select button is pushed.) 4. The channel indicator will then come on and the sound will resume. Memorizing is now complete. 5. Other buttons can be set in the same manner. If the battery cable is disconnected, or if the fuse blows, the radio memory will be erased. In that case, reset the desired stations. Compact Disc (CD) player/changer operation Push the ignition switch to the ACC or ON position, push the LOAD button (if so equipped) and insert the compact disc into the slot with the label side facing up. The compact disc will be guided automatically into the slot and start playing. After loading the disc, the number of tracks on the disc and the play time will appear on the display. If the radio is already operating, it will automatically turn off and the compact disc will play. If the system has been turned off while the compact disc was playing, pushing the 4-46 Monitor, heater, air conditioner, audio, phone and voice recognition systems