2010 Nissan Murano Owner's Manual - Page 247

BLUETOOTH® HANDS-FREE PHONE SYSTEM WITH NAVIGATION SYSTEM CAUTION . Keep the antenna as far away as possible from the electronic control modules. Keep the antenna wire more than 8 in (20 cm) away from the electronic control system harness. Do not route the antenna wire next to any harness. Adjust the antenna standing-wave ratio as recommended by the manufacturer. Connect the ground wire from the CB radio chassis to the body. For details, consult a NISSAN dealer. . WARNING Use a phone after stopping your vehicle in a safe location. If you have to use a phone while driving, exercise extreme caution at all times so full attention may be given to vehicle operation. If you find yourself unable to devote full attention to vehicle operation while talking on the phone, pull off the road to a safe location and stop your vehicle before doing so. procedure is required anymore. Your phone is automatically connected with the in-vehicle phone module when the ignition switch is pushed to the ON position with the registered cellular phone turned on and carried in the vehicle. You can register up to 5 different Bluetooth® cellular phones in the in-vehicle phone module. However, you can talk on only one cellular phone at a time. The NISSAN Voice Recognition system supports the phone commands, so dialing a phone number using your voice is possible. For more details, see "NISSAN VOICE RECOGNITION SYSTEM (models with navigation system)" later in this section; page 4-99. Before using the Bluetooth® Hands-Free Phone System, refer to the following notes. . ® . . . . . CAUTION To avoid draining the vehicle battery, use a phone after starting the engine. Your NISSAN is equipped with Bluetooth Hands-Free Phone System. If you are an owner of a compatible Bluetooth® enabled cellular phone, you can set up the wireless connection between your cellular phone and the in-vehicle phone module. With Bluetooth® wireless technology, you can make or receive a telephone call with your cellular phone in your pocket. Once your cellular phone is paired to the invehicle phone module, no phone connecting Set up the wireless connection between a cellular phone and the in-vehicle phone module before using the Bluetooth ® Hands-Free Phone System. Some Bluetooth® enabled cellular phones may not be recognized by the in-vehicle phone module. Please visit www.nissanusa.com/bluetooth for a recommended phone list. You will not be able to use a hands-free phone under the following conditions: . . Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-75