2010 Nissan Murano Owner's Manual - Page 263

Once you have confirmed the name and location, the system begins the call. (speak digits) When prompted by the system, say the number you wish to call. (See "How to say numbers" earlier in this section and "MAKING A CALL BY ENTERING A PHONE NUMBER" earlier in this section for more details.) "Redial" Use the Redial command to call the last number that was dialed within the vehicle. NOTE: The system will not redial the last number dialed by the handset keypad. The system acknowledges the command, repeats the number and begins dialing. If a redial number does not exist, the system announces, "There is no number to redial" and ends the VR session. "Callback" Use the Call Back command to dial the number of the last incoming call within the vehicle. The system acknowledges the command, repeats the number and begins dialing. If a call back number does not exist, the system announces, "There is no number to call back" and ends the VR session. International For dialing more than 10 digits or any special characters, please say "Call International". When the system acknowledges the command, the system will prompt you to speak the number. During a call During a call there are several command options available. Press the button on the steering wheel to mute the receiving voice and enter commands..."Help" - The system announces the available commands. "Go back/Correction" - The system announces "Go back," ends the VR session and returns to the call. "Cancel/Quit" - The system announces "Cancel," ends the VR session and returns to the call. "Send/Enter/Call/Dial" - Use the Send command to enter numbers during a call. For example, if you were directed to dial an extension by an automated system: Say: "Send one two three four." The system acknowledges the command and sends the tones associated with the . . numbers. The system then ends the VR session and returns to the call. "Transfer Call" - Use the Transfer Call command to transfer the call from the Bluetooth® Hands-Free Phone System to the cellular phone when privacy is desired. The system announces, "Transfer call. Call transferred to privacy mode." The system then ends the VR session. You can also issue the Transfer Call command again to return to a hands-free call through the vehicle. "Mute" - Use the Mute command to mute your voice so the other party cannot hear it. Use the mute command again to unmute your voice. . . NOTE: If the other party ends the call or the cellular phone network connection is lost while the Mute feature is on, the Mute feature may need to be reset to "off." Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-91