2010 Nissan Murano Owner's Manual - Page 217

ON·OFF/Volume control: Push the ignition switch to the ACC or ON position, and then push the ON·OFF/VOLUME control knob while the system is off to call up the mode (radio, CD or AUX) which was playing immediately before the system was turned off. While the system is on, pushing the ON·OFF/ VOLUME control knob turns the system off. Turn the ON·OFF/VOLUME control knob to adjust the volume. Adjusting tone quality and speaker balance: To adjust Bass, Treble, Balance and Fade, push the Audio control knob. When the display shows the setting you want to change (Bass, Treble, Balance and Fade), rotate the Audio control knob to set the desired setting. For the other setting methods, see "HOW TO USE SETTING BUTTON" earlier in this section. This vehicle has some sound effect functions as follows (if so equipped): . Speed Sensitive Volume displays as follows: CD ? CompactFlash* ? DVD* ? AUX ? iPod®* ? Music Box* ? CD *: if so equipped pushed to ON. The satellite radio mode requires an active XM® satellite radio service subscription. Satellite radio is not available in Alaska, Hawaii and Guam. If another audio source is playing when the radio band select button is turned to ON, the audio source will automatically be turned off and the last radio station played will come on. When the stereo broadcast signal is weak, the radio will automatically change from stereo to monaural reception. TUNE (Tuning): . For AM and FM radio Turn the TUNE/FOLDER knob for manual tuning. . For XM satellite radio Turn the TUNE/FOLDER knob to seek channels from all of the categories when any CAT is not selected. SEEK tuning/CATEGORY (CAT): . For AM and FM radio Push the SEEK·CAT or TRACK button or to tune from low to high or high to AM-FM-SAT radio operation radio (FM/AM) band select: Pushing the radio band select button will change the band as follows: AM ? FM1 ? FM2 ? AM or radio (SAT) band select: Pushing the radio band select button will change the band as follows: (With navigation system) SAT1 ? SAT2 ? SAT1 (Without navigation system) AUX ? SAT1 ? SAT2 ? AUX When the radio band select button is pushed while the ignition switch is in the ACC or ON position, the radio will come on at the station last played. The last station/channel played will also come on when the ON·OFF/VOL control knob is For more details, see "VEHICLE INFORMATION AND SETTINGS" earlier in this section. Switching the display (for models with navigation system): Pushing the DISC·AUX button will switch the Monitor, heater, air conditioner, audio, phone and voice recognition systems 4-45