2013 Nissan Sentra Owner's Manual - Page 181

● Do not connect a USB device if a connector, cable or USB port is wet. Allow the connector, cable, and USB port to dry completely before connecting the USB device. (Wait for 24 hours or more until it is dry.) If the connector and USB port are exposed to fluids other than water, evaporative residue may cause a short circuit between the connector pins and USB port. In this case, replace the cable and USB port. Otherwise damage to the USB device and a loss of function may occur. ● If the cable is damaged (insulation cut, connectors cracked, contamination such as liquids, dust, dirt, etc. in the connectors), do not use the cable. Replace the cable with a new one. ● Do not put a USB device in a location where static electricity occurs, electrical noise is generated or hot air from the air conditioner blows directly on it. Doing so may cause the data stored on the USB device to be corrupted. Notes for iPod® use: iPod® is a trademark of Apple Inc., registered in the U.S. and other countries. ● Improperly plugging in the iPod may cause a checkmark to be displayed on and off (flickering). Always make sure that the iPod is connected properly. ● An iPod® nano (1st Generation) may remain in fast forward or rewind mode if it is connected during a seek operation. In this case, please manually reset the iPod. ● An iPod® nano (2nd Generation) will continue to fast-forward or rewind if it is disconnected during a seek operation. ● An incorrect song title may appear when the Play Mode is changed while using an iPod® nano (2nd Generation). ● Audiobooks may not play in the same order as they appear on an iPod®. ● Large video files cause slow responses in an iPod®. The vehicle center display may momentarily black out, but will soon recover. ● If an iPod® automatically selects large video files while in the shuffle mode, the vehicle center display may momentarily black out, but will soon recover. ● Operating procedure of the Bluetooth® audio will vary depending on the devices. Make sure how to operate your audio device before using it with this system. ● The Bluetooth® audio may be stopped under the following conditions: ● Receiving a call on the Hands-Free Phone System. ● Checking the connection to the handsfree phone. ● Do not place the Bluetooth® audio device in an area surrounded by metal or far away from the in-vehicle Bluetooth® module to prevent tone quality degradation and wireless connection disruption. ● While an audio device is connected through the Bluetooth® wireless connection, the battery power of the device may discharge quicker than usual. ● This system supports the Bluetooth® Audio Distribution Profile (A2DP, AVRCP). Bluetooth® streaming audio (if so equipped) ● Some Bluetooth® audio devices may not be recognized by the in-vehicle audio system. ● It is necessary to set up the wireless connection between a compatible Bluetooth® audio device and the in-vehicle Bluetooth® module before using the Bluetooth® audio. BLUETOOTH® is a trademark owned by Bluetooth SIG, Inc. and licensed to Visteon and Bosch. 4-34 Monitor, climate, audio, phone and voice recognition systems