2013 Nissan Sentra Owner's Manual - Page 202
2013 Nissan Sentra Manual
Page 202 highlights
● Do not force the iPod® cable into the USB port. Inserting the USB device tilted or up-side-down into the port may damage the iPod® cable and the port. Make sure that the iPod® cable is connected correctly into the USB port. (Some iPod® cables come with a mark as a guide. Make sure that the mark is facing the correct direction before inserting the iPod® cable.) ● Do not locate objects near the iPod® cable to prevent the objects from leaning on the iPod® cable and the port. Pressure from the objects may damage the iPod® cable and the port. To connect an iPod® to the vehicle so that the iPod® can be controlled with the audio system controls and display screen, use the USB jack 1 . Connect the located in the center console ᭺ iPod®-specific end of the cable to the iPod® and the USB end of the cable to the USB jack on the vehicle. If your iPod® supports charging via a USB connection, its battery will be charged while connected to the vehicle with the ignition switch in the ACC or ON position. While connected to the vehicle, the iPod® can only be o perated by the vehicle audio controls. To disconnect the iPod® from the vehicle, remove the USB end of the cable from the USB jack on the vehicle, then remove the cable from the iPod®. * iPod® is a trademark of Apple Inc., registered in the U.S. and other countries. ● Fourth generation iPod nano® (Firmware version 1.0.4 or later) ● Fifth generation iPod nano® (Firmware version 1.0.1 or later) The iPod touch® may not respond quickly with the system in some cases. Make sure that the iPod® firmware is updated. Compatibility The following models are available: ● Fifth generation iPod® (Firmware version 1.2.1 or later) ● First generation iPod Classic® (Firmware version 1.1 or later) ● Second generation iPod Classic® (Firmware version 2.0.3 or later) ● First generation iPod touch® (Firmware version 2.1.0 or later) ● Second and third generation iPod touch® (Firmware version 3.1.2 or later) ● First generation iPod nano® (Firmware version 1.3.1 or later) ● Second generation iPod nano® (Firmware version 1.1.3 or later) ● Third generation iPod nano® (Firmware version 1.0.2 or later) Audio main operation Place the ignition switch to the ACC or ON position. Then, press the CD·AUX or iPod® MENU button repeatedly to switch to the iPod® mode. If the audio system is turned off while the iPod® is playing, the iPod® plays when the audio system is turned back on. If the audio system is off, pressing the CD·AUX or iPod® MENU button turns the audio system on and plays the iPod®. If the audio system is on, the audio system automatically begins playing tracks from the iPod® when it is plugged into the jack. iPod® MENU button: Press the iPod® MENU button while the iPod® is connected to show the iPod® operation menu on the audio display. Scroll through the menu list using the TUNE·SCROLL control dial. Press EN- Monitor, climate, audio, phone and voice recognition systems 4-55