2013 Nissan Sentra Owner's Manual - Page 88

Operation The Malfunction Indicator Light will come on in one of two ways: ● Malfunction Indicator Light on steady - An emission control system malfunction has been detected. Check the fuel-filler cap if the LOOSE FUEL CAP warning appears in the vehicle information display. If the fuelfiller cap is loose or missing, tighten or install the cap and continue to drive the vehicle. light should turn off after a few The driving trips. If the light does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. ● Malfunction Indicator Light blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: - do not drive at speeds above 45 MPH (72 km/h). - avoid hard acceleration or deceleration. - avoid steep uphill grades. - if possible, reduce the amount of cargo being hauled or towed. The Malfunction Indicator Light may stop blinking and come on steady. Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. For vehicles with Intelligent Key: This light blinks when the ignition switch is placed in the LOCK position with the key removed from the ignition switch. The blinking security indicator light indicates that the security systems equipped on the vehicle are operational. For additional information, see "Security systems" later in this section. CAUTION Continued vehicle operation without having the emission control system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system. Side light and headlight indicator light (green) The side light and headlight indicator light illuminates when the side light or headlight position is selected. See "Headlight and turn signal switch" later in this section for further details. Overdrive off indicator light (CVT models) The overdrive off indicator light illuminates when the overdrive off mode is selected. For additional information, see "Continuously Variable Transmission (CVT)" in the "Starting and driving" section of this manual. Slip indicator light This indicator will blink when the VDC system or the traction control system is operating, thus alerting that the vehicle is nearing its traction limits. The road surface may be slippery. Security indicator light For vehicles without Intelligent Key: This light blinks whenever the ignition switch is placed in the LOCK, OFF or ACC position. Instruments and controls 2-19