2014 Nissan Rogue Owner's Manual - Page 115
2014 Nissan Rogue Manual
Page 115 highlights
Auto-reverseGUID-CD58E688-0E5F-4849-A2F9-9DCE763F2A71 function (if so equipped) If the windows do not close automatically GUID-4366A858-91A3-4739-91C0-DACFB774B6DE If the power window automatic function (closing only) does not operate properly, perform the following procedure to initialize the power window system. 1. Turn the ignition switch to the ON position. 2. Close the door. 3. Open the window completely by operating the power window switch. 4. Pull the power window switch and hold it to close the window, and then hold the switch more than 3 seconds after the window is closed completely. 5. Release the power window switch. Operate the window by the automatic function to confirm the initialization is complete. If the power window automatic function does not operate properly after performing the procedure above, have your vehicle checked by a NISSAN dealer. WARNING There are some small distances immediately before the closed position which cannot be detected. Make sure that all passengers have their hands, etc., inside the vehicle before closing the window. If the control unit detects something caught in the window as it is closing, the window will be immediately lowered. The auto reverse function can be activated when the window is closed by automatic operation when the ignition switch is in the ON position or for 45 seconds after the ignition switch is turned to the OFF position. Depending on the environment or driving conditions, the auto reverse function may be activated if an impact or load similar to something being caught in the window occurs. SIC3509 Automatic operation (if so equipped) GUID-E7474ECC-09DE-4A54-A358-7896B84E25A1 The automatic operation is available for the switch that has an mark on its surface. To fully open or close the window, push down or pull up the switch to the second detent and release it; the switch need not be held. The window will automatically open or close all the way. To stop the window, just push or lift the switch in the opposite direction. A light push or pull on the switch will cause the window to open or close until the switch is released. Instruments and controls 2-43