2014 Nissan Rogue Owner's Manual - Page 99

security system is now pre-armed. After about 30 seconds the vehicle security system automatically shifts into the armed phase. The security light begins to flash once every approximately 3 seconds. If, during this 30-second pre-arm time period, the door is unlocked, or the ignition switch is turned to the ACC or ON position, the system will not arm. Even when the driver and/or passengers are in the vehicle, the system will activate with all doors locked with the ignition switch in the LOCK position. When turning the ignition switch to the ACC or ON position, the system will be released. alarm will activate.) How to stop GUID-22EF1D00-401F-445E-9D49-7B8AEBA716D0 an activated alarm The alarm will stop by unlocking a door by pushing the unlock button on the keyfob, or using the key. The alarm will not stop if the ignition switch is turned to the ACC or ON position. If the system does not operate as described above, have it checked by a NISSAN dealer. 4. Restart the engine while holding the device (which may have caused the interference) separate from the registered key. If this procedure allows the engine to start, NISSAN recommends placing the registered key on a separate key ring to avoid interference from other devices. Statement related to section 15 of FCC rules for NISSAN Vehicle Immobilizer System (CONT ASSY-BCM. ANT ASSYIMMOBILISER) FCC Notice: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTE: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. NISSAN VEHICLE IMMOBILIZER SYSTEM GUID-52296442-4547-4FA1-9662-0A05BE6E48F5 The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of the registered key. If the engine fails to start using the registered key, it may be due to interference caused by another registered key, an automated toll road device or automated payment device on the key ring. Restart the engine using the following procedures: 1. Leave the ignition switch in the ON position for approximately 5 seconds. 2. Turn the ignition switch to the OFF or LOCK position and wait approximately 10 seconds. 3. Repeat step 1 and 2 again. Vehicle security system activation GUID-E0994200-F9B0-476C-AF5D-4AFA2F5FF981 The vehicle security system will give the following alarm: . The headlights blink and the horn sounds intermittently. . The alarm automatically turns off after approximately 50 seconds. However, the alarm reactivates if the vehicle is tampered with again. The alarm is activated by: . Unlocking the door without using the keyfob, or the key. (Even if the door is opened by releasing the door inside lock knob, the Instruments and controls 2-27