2014 Nissan Rogue Owner's Manual - Page 213

VEHICLE DYNAMIC CONTROL (VDC) SYSTEM S35-D-110201-D6FDB021-412C-46AD-9A43-77A8616112D0 Using the system S35-D-110201-EECE86D6-FF8F-42C2-B139-BF05AF32B3BE Depress the brake pedal and hold it down. Depress the brake pedal with firm steady pressure, but do not pump the brakes. The ABS will operate to prevent the wheels from locking up. Steer the vehicle to avoid obstacles. self-test or while driving, have the vehicle checked by a NISSAN dealer. Normal S35-D-110201-3C7B8B73-5F7B-44E6-B702-4024AAD51CEB operation The ABS operates at speeds above 3 to 6 MPH (5 to 10 km/h). The speed varies according to road conditions. When the ABS senses that one or more wheels are close to locking up, the actuator rapidly applies and releases hydraulic pressure. This action is similar to pumping the brakes very quickly. You may feel a pulsation in the brake pedal and hear a noise from under the hood or feel a vibration from the actuator when it is operating. This is normal and indicates that the ABS is operating properly. However, the pulsation may indicate that road conditions are hazardous and extra care is required while driving. The Vehicle Dynamic Control (VDC) system uses various sensors to monitor driver inputs and vehicle motion. Under certain driving conditions, the VDC system helps to perform the following functions. . Controls brake pressure to reduce wheel slip on one slipping drive wheel so power is transferred to a non slipping drive wheel on the same axle. . Controls brake pressure and engine output to reduce drive wheel slip based on vehicle speed (traction control function). . Controls brake pressure at individual wheels and engine output to help the driver maintain control of the vehicle in the following conditions: - understeer (vehicle tends to not follow the steered path despite increased steering input) - oversteer (vehicle tends to spin due to certain road or driving conditions). The VDC system can help the driver to maintain control of the vehicle, but it cannot prevent loss of vehicle control in all driving situations. When the VDC system operates, the VDC warning light in the instrument panel flashes so note the following: . The road may be slippery or the system may determine some action is required to help Starting and driving 5-27 WARNING Do not pump the brake pedal. Doing so may result in increased stopping distances. Self-test feature S35-D-110201-B89EE4B7-4EC0-42A0-AAC9-0035053E8A9B The ABS includes electronic sensors, electric pumps, hydraulic solenoids and a computer. The computer has a built-in diagnostic feature that tests the system each time you start the engine and move the vehicle at a low speed in forward or reverse. When the self-test occurs, you may hear a "clunk" noise and/or feel a pulsation in the brake pedal. This is normal and does not indicate a malfunction. If the computer senses a malfunction, it switches the ABS off and illuminates the ABS warning light on the instrument panel. The brake system then operates normally, but without anti-lock assistance. If the ABS warning light illuminates during the