2014 Nissan Rogue Owner's Manual - Page 87
2014 Nissan Rogue Manual
Page 87 highlights
High beam indicator light S35-D-110201-07BD5427-AE0D-485E-80A5-812FA0319F8E This light illuminates when the headlight high beam is on and goes out when the low beam is selected. Operation: GUID-D73A39BF-43C8-459F-9C24-47B7F579C407 The malfunction indicator light will illuminate in one of two ways: . Malfunction indicator light illuminated steady - An emission control system and/or CVT malfunction has been detected. Check the fuel-filler cap if the LOOSE FUEL CAP warning appears in the vehicle information display. If the fuel-filler cap is loose or missing, tighten or install the cap and continue to drive the vehicle. The light should turn off after a few driving trips. If the light does not turn off after a few driving trips, have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. Malfunction indicator light blinking - An engine misfire has been detected which may damage the emission control system. To reduce or avoid emission control system damage: - Do not drive at speeds above 45 MPH (72 km/h). - Avoid hard acceleration or deceleration. - Avoid steep uphill grades. - If possible, reduce the amount of cargo being hauled or towed. The malfunction indicator light may stop blinking and remain illuminated. Have the vehicle inspected by a NISSAN dealer. You do not need to have your vehicle towed to the dealer. Malfunction Indicator Light (MIL) S35-D-110201-F2AAEA88-0C31-456F-B0D1-06BE0BA285F5 If the malfunction indicator light illuminates steady or blinks while the engine is running, it may indicate a potential emission control and/or Continuously Variable Transmission (CVT) malfunction. The malfunction indicator light may also illuminate steady if the fuel-filler cap is loose or missing, or if the vehicle runs out of fuel. Check to make sure the fuel-filler cap is installed and closed tightly, and that the vehicle has at least 3 US gallons (11.4 liters) of fuel in the fuel tank. After a few driving trips, the light should turn off if no other potential emission control system malfunction exists. If this indicator light remains on for 20 seconds and then blinks for 10 seconds when the engine is not running, it indicates that the vehicle is not ready for an emission control system inspection/ maintenance test. (See "Readiness for Inspection/Maintenance (I/M) test" (P.9-27).) CAUTION Continued vehicle operation without having the emission control system and/or CVT system checked and repaired as necessary could lead to poor driveability, reduced fuel economy, and possible damage to the emission control system. Overdrive off indicator light S35-D-110201-DB3484E2-4E19-4E8D-8653-05337ABAC493 The overdrive off indicator light illuminates when the overdrive off mode is selected. For additional information, see "Continuously Variable Transmission (CVT)" (P.5-10) of this manual. . Security indicator light S35-D-110201-96187D83-25D7-49DD-B539-C22AB5E56EEC The light blinks when the ignition switch is in the ACC, OFF or LOCK position. This function indicates the security system equipped on the vehicle is operational. If the security system is malfunctioning, this light will remain on while the ignition switch is in the Instruments and controls 2-15