2014 Nissan Rogue Owner's Manual - Page 201
2014 Nissan Rogue Manual
Page 201 highlights
turned on, the switch or system may have a malfunction. In this case, contact your NISSAN dealer. Even if there is a malfunction in the switch or system, this will not affect normal driving...The SPORT mode automatically turns off if a malfunction occurs. The SPORT mode only operates at speeds of above 20 MPH (30km/h). If the engine is switched off with the SPORT mode on, the SPORT mode resets to off when the engine is restarted. JVS0097X Accelerator downshift - In D position - S35-D-110201-F9EEE14F-5BF2-4256-B19A-D9E9E24F5809 For passing or hill climbing, fully depress the accelerator pedal to the floor. This shifts the transmission down into a lower gear, depending on the vehicle speed. High fluid temperature protection mode S35-D-110201-481FB4B1-F6C4-49B8-8504-1DFAEEA834E0 This transmission has a high fluid temperature protection mode. If the fluid temperature becomes too high (for example, when climbing steep grades in high temperature with heavy loads, such as when towing a trailer), engine power and, under some conditions, vehicle speed will be decreased automatically to reduce the chance of transmission damage. Vehicle speed can be controlled with the accelerator pedal, but the engine and vehicle speed may be limited. CAUTION . . In the SPORT mode, fuel economy may be reduced. If the overdrive off mode is set when the SPORT mode is on, the overdrive off mode will take priority. Overdrive (O/D) OFF switch S35-D-110201-6B915A43-9062-4BFB-A3D9-25A6FE35E78C When the O/D OFF switch is pushed with the shift lever in the D (Drive) position, the indicator light in the instrument panel illuminates. Use the overdrive off mode when you need improved engine braking. To turn off the overdrive off mode, push the O/D OFF switch again. The indicator light will turn off. Each time the engine is started, or when the shift lever is shifted to any position other than the D (Drive) position, the overdrive off mode will be automatically turned off. Fail-safe S35-D-110201-A143CA3E-686B-4C25-9A61-E13835FDD47C If the vehicle is driven under extreme conditions, such as excessive wheel spinning and subsequent hard braking, the fail-safe system may be activated. The MIL may illuminate to indicate the fail-safe mode is activated. (See "Malfunction Indicator Light (MIL)" (P.2-15).) This will occur even if all electrical circuits are functioning properly. In this case, turn the ignition switch to the OFF position and Starting and driving 5-15