2014 Nissan Rogue Owner's Manual - Page 198
2014 Nissan Rogue Manual
Page 198 highlights
DRIVING THE VEHICLE NOTE: Care should be taken to avoid situations that can lead to potential battery discharge and potential no-start conditions such as: 1. Installation or extended use of electronic accessories that consume battery power when the engine is not running (Phone chargers, GPS, DVD players, etc.) 2. Vehicle is not driven regularly and/or only driven short distances. In these cases, the battery may need to be charged to maintain battery health. S35-D-110201-B37603AF-ECB2-481C-A92E-035B1AB0690B CONTINUOUSLY VARIABLE TRANSMISSION (CVT) S35-D-110201-5418F86B-BA47-41F8-8576-D09AB3751BAF The Continuously Variable Transmission (CVT) in your vehicle is electronically controlled to produce maximum power and smooth operation. The recommended operating procedures for this transmission are shown on the following pages. Follow these procedures for maximum vehicle performance and driving enjoyment. Engine power may be automatically reduced to protect the CVT if the engine speed increases quickly when driving on slippery roads or while being tested on some dynamometers. 2. Keep the foot brake pedal depressed, push the shift lever button and move the shift lever to a driving position. 3. Release the parking brake and foot brake pedal, and then gradually start the vehicle in motion. WARNING . Do not depress the accelerator pedal while shifting from P (Park) or N (Neutral) to R (Reverse), D (Drive), L (Low). Always depress the brake pedal until shifting is completed. Failure to do so could cause you to lose control and have an accident. Cold engine idle speed is high, so use caution when shifting into a forward or reverse gear before the engine has warmed up. Never shift to P (Park) or R (Reverse) while vehicle is moving. Failure to do so could cause you to lose control and have an accident. StartingS35-D-110201-09A6574C-D46F-4EF2-9E5A-FADC6C34FAE0 the vehicle 1. After starting the engine, fully depress the foot brake pedal before moving the shift lever out of the P (Park) position. This CVT is designed so that the foot brake pedal must be depressed before shifting from P (Park) to any driving position while the ignition switch is in the ON position. The shift lever cannot be moved out of the P (Park) position and into any of the other positions if the ignition switch is turned to the LOCK, OFF or ACC position or if the key is removed. . . 5-12 Starting and driving