2000 Saab 9-3 Owner's Manual - Page 110

110 Saab 9-3 Audio System WARNING Always consult an authorized Saab dealer for installation guidance. If you feel that any of the warnings or fault indications are unclear, have the equipment checked by an authorized Saab dealer. TAPE ERR 02/03 TAPE ERR 11 Tape snarled up or mechanical fault in deck. Cassette jammed: cannot be loaded/ejected. Mobile phones and communications radios Mobile phones and communications radios that do not have a separate external antenna radiate an electromagnetic field inside the car. WARNING The electromagnetic field inside the car can be detrimental to your health. WARNING The CD player/CD changer is classified as Class 1 laser equipment. • Service and repair work must only be carried out by authorized technicians. • If the casing is damaged, hazardous laser radiation can occur. Fault codes NOTE Great care should be exercised in trying to rectify a fault. If you are at all unsure, contact an authorized Saab dealer. The Audio System has a built-in diagnostics function. If a fault is detected, a fault code is generated to help dealer technicians to diagnose the fault. Below is an example of a fault code that you might be able to rectify yourself. Fault code CD/CDC ERROR 12/17/19 TAPE ERR 01 Possible cause CD is dirty, loaded wrong side up or defective. Tape broken or mechanical fault in deck. NOTE The electromagnetic field can cause interference with other electrical systems in the car, such as the Audio System. Saab therefore recommends that a car phone/radio transmitter should always be connected to an external antenna. An external antenna also provides improved transmission/reception and a greater range. Mobile phones and communications radios that are not supplied as standard equipment by Saab can interfere with the car's electrical system and cause misleading fault codes to be generated. Adjusting the frequency steps North America/Europe If the car is taken from Europe to North America, the radio's frequency steps will need to be adjusted. • With the radio off, press and hold SEEK (mid-segment) and switch the radio on at the same time. The station presets will be cancelled and replaced by preset frequencies.