2000 Saab 9-3 Owner's Manual - Page 86

86 Instruments and controls Programming I The manual selections you have made can be saved so that the ACC system always starts up on these selections every time the ignition is switched on. But notice that the ignition must have been off for at least 10 minutes before you try out the saved setting. 1 Select the desired settings. 2 Press + at the same time. (The ACC background lighting flashes to confirm that the information has been stored.) Example: If you want the ACC system to distribute the air to the dash vents from the start, proceed as follows: 1 Start the engine. 2 Press the button . Calibration If the battery has been disconnected or has run flat, the system will recalibrate automatically. Manual calibration: 1 Start the engine. 2 Press + at the same time. The ACC display flashes once to indicate that calibration and self-testing have started. During calibration the display indicates the figure 0 or the fault codes (01-23) that have been found. Calibration and self-testing takes about 30 seconds. 3 Press and at the same time. 4 Shut off the key. 5 The system will memorize this new program 10 minutes after the key is shut off. Cancelling program I A saved setting is deleted only by pressing + at the same time. (The ACC display flashes to confirm that deletion has been effected.)