2006 Suzuki Reno Owner's Manual - Page 122
2006 Suzuki Reno Manual
Page 122 highlights
INSTRUMENT PANEL seconds, then go on to the next station. Press this button again to stop scanning. The radio will only scan stations with a strong signal that are in the selected band. Automatic Store Press this button for longer than two seconds to use Automatic Store. FM1's six preset stations with the strongest signal in the region can be automatically stored. The display will show "AUTO SCANNING" and "SCANNING" will flash on the display. Stored stations will flash for a short time on the display in sequence. Once the stations are stored, the radio will switch to FM1 and the first preset station will begin to play. "FM-A" will appear on the display when listening to the automatically stored stations. Press the AM or FM button to cancel the automatic store function. Preset station buttons (7): Setting Preset Stations Up to 24 stations (six FM1, six FM2, six AM1, and six AM2), can be programmed on the preset station buttons (7), by performing the following steps: 1) Turn the radio on. 2) Press the AM or FM button to select FM1, FM2, AM1 or AM2. 3) Tune in the desired station. 4) Press and hold one of the preset station buttons for longer than two seconds. The corresponding preset button number will flash on the display when the station has been set. Whenever that numbered preset button is pressed, the memorized station will be tuned in. 5) Repeat the previous four steps for each preset button. SOUND BUTTON SCROLL ORDER When you repeatedly press the SOUND button, the functions will scroll in the following order: BASS, TRE, BAL, FADE, EQ OFF, and VOL. SOUND button (8): Setting the Tone (Bass/Treble) Press the SOUND button until "BAS" appears on the display. Turn the volume knob to increase or to decrease the bass. The display will show the bass level. When finished making the selection, press the SOUND button to set the bass level selection. Press the SOUND button until "TRE" appears on the display. Turn the volume knob to increase or to decrease the treble. The display will show the treble level. When finished making the selection, press the SOUND button to set the treble level selection. If a station is weak or noisy, decrease the treble. Adjusting the Speakers (Balance/Fade) To adjust the balance between the right and the left speakers, press the SOUND button until "BAL" appears on the display. Turn the volume knob to shift the balance between the right and left speakers. The display will show the balance level. When finished making the selection, press the SOUND button to set the balance level. To adjust the fade between the front and the rear speakers, press the SOUND but- 3-49