2009 Suzuki SX4 Owner's Manual - Page 68
2009 Suzuki SX4 Manual
Page 68 highlights
Lighting/Turn Signal Control Lever: 8 STEERING COLUMN CONTROLS • If the keyless start system red indicator light illuminates, the remote controller may not be in the vehicle or the battery of the remote controller may be unreliable. NOTE: • If the battery of the remote controller runs down or there are strong radio waves or noise, the operating range may be narrower or the remote controller may be inoperative. • If the remote controller is too close to the door glass, it may not operate. • The ignition switch may not turn when the remote controller is on the instrument panel, in the glove box, in a storage compartment, in the sun visor or on the floor. If you leave any of the doors open with the ignition switch in the "ACC" position for a while (and no key inserted), the engine may not start when you turn the ignition switch to "START". If the engine does not start, close all doors completely or turn the ignition switch back to the "LOCK" position, then start the engine. The ignition switch has the following four positions: LOCK (1) This is the normal parking position. It is the only position in which the key can be removed. It locks the ignition, and prevents normal use of the steering wheel. For vehicles with an automatic transaxle, the gearshift lever must be in the "P" (Park) position to turn the key to the "LOCK" position. To release the steering lock, turn the ignition switch clockwise to one of the other positions. If you have trouble turning the ignition switch to unlock the steering, try turning the steering wheel slightly to the right or left while turning the switch. • Manual transaxle vehicle You must push in the ignition switch to turn it from the "LOCK" position to the "ACC" position. To return to the "LOCK" position from the "ACC" position, turn the ignition switch counterclockwise while pushing in the switch. • Automatic transaxle vehicle To turn the ignition switch, push the switch. ACC (2) Accessories such as the radio can operate, but the engine is off. ON (3) This is the normal operating position. All electrical systems are on. START (4) This is the position for starting the engine using the starter motor. The switch should be released from this position as soon as the engine starts. Ignition switch reminder (When using the keyless start system) A buzzer sounds intermittently to remind you to return the ignition switch to the "LOCK" position if it is in the "ACC" position when the driver's door is opened. Ignition key reminder (When using the ignition key) A buzzer sounds intermittently to remind you to remove the ignition key if it is in the ignition switch when the driver's door is opened. CAUTION The remote controller is a sensitive electronic instrument. To avoid damaging the remote controller: • Do not expose it to impacts, moisture or high temperature such as by leaving it on the dashboard under direct sunlight. • Keep the remote controller away from magnetic objects such as a television. You can also turn the ignition switch by inserting the ignition key into the slot. 3-3 80J22-03E