Alpine CDE-124SXM Owner's Manual (english) - Page 41

iPod/iPhone Connection (sold separately) 1 Connect USB cable to an iPod/iPhone with Interface cable for iPod. Remove the iPod/iPhone Remove the iPod/iPhone from Interface cable for iPod. USB cable (CDE-124SXM/CDE-122, sold separately; CDE-123, supplied) Interface cable for iPod (CDE-124SXM/CDE-122, sold separately; CDE-123, supplied) 2 Connect the USB cable to the USB connector of this unit. When connect to Front USB Connection Terminal 1 Open the cover of the USB Connection Terminal. 2 Connect the Interface cable for iPod directly to the USB Connection Terminal, or via the USB cable. This unit USB Connection Terminal or Notes • This unit can charge the iPod/iPhone of the current source, and it may stop charging when another source is switched. • After changing the unit to a source other than the USB iPod, remove the iPod/iPhone. If the iPod/iPhone is removed in the USB iPod mode, data may cause damage. • If sound is not output or the iPod/iPhone is not recognized even when the iPod/iPhone is connected, remove the iPod/iPhone once, then connect it again, or reset the iPod. • Do not leave the iPod/iPhone in a vehicle for a long time. Heat and humidity may damage the iPod/iPhone and you may not be able to play it again. Rear Flash Memory Connection (CDE-123 only) (sold separately) Connect Flash Memory Connect the USB cable to the Rear USB connector of the unit, and then secure the connection using the lock case supplied with USB cable as shown below. This unit lock case Flash Memory (sold separately) Cable (supplied) USB Connector Interface cable for iPod (CDE-124SXM/CDE-122, sold separately; CDE-123, supplied) Cable (sold separately) When connect to Rear USB Connector (CDE-123 only) Connect the USB cable to the Rear USB connector of the unit, and then secure the connection using the lock case supplied with USB cable as shown below. This unit Interface cable for iPod (supplied) lock case Cable (supplied) Rear USB Connector Remove Flash Memory Pull out Flash Memory squarely from the USB cable. This unit USB Connector Flash Memory (sold separately) Cable (supplied) Notes • When removing Flash Memory, pull it out straight. • If sound is not output or Flash Memory is not recognized even when Flash Memory is connected, remove Flash Memory once, then connect it again. • Change to a source other than the Flash Memory mode, then remove the Flash Memory. If the Flash Memory is removed in the Flash Memory mode, data may be damaged. • Route the USB cable away from another cables. 41-EN