Alpine CDE-154BT Owner's Manual (english) - Page 48

iPod/iPhone Connection (sold separately) Connect USB cable to an iPod/iPhone with Interface cable for iPod. USB cable (Supplied) Interface cable for iPod (included with iPod/iPhone) Remove the iPod/iPhone Remove the iPod/iPhone from Interface cable for iPod. • Change to a source other than the Flash Memory mode, then remove the Flash Memory. If the Flash Memory is removed in the Flash Memory mode, data may be damaged. • Route the USB cable away from another cables. Mounting the Microphone For the sake of safety, mount the microphone in the following location. • In a stable and secure location. • In a location that does not inhibit safely driving the vehicle. • Mount the microphone in a location where the driver's voice can easily be picked up. Choose a location for the microphone that can easily pick up the drivers voice. Requiring the driver to move towards the microphone for audibility causes a distraction that could be dangerous. Notes • After changing the unit to a source other than the USB iPod, remove the iPod/iPhone. If the iPod/iPhone is removed in the USB iPod mode, data may cause damage. • If sound is not output or the iPod/iPhone is not recognized even when the iPod/iPhone is connected, remove the iPod/iPhone once, then connect it again, or reset the iPod. • Do not leave the iPod/iPhone in a vehicle for a long time. Heat and humidity may damage the iPod/iPhone and you may not be able to play it again. Flash Memory Connection (sold separately) Connect Flash Memory Connect the USB cable to the USB connector of the unit. This unit Flash Memory (sold separately) USB Cable (Supplied) USB Connector Remove Flash Memory Pull out Flash Memory squarely from the USB cable. This unit USB Connector Flash Memory (sold separately) USB Cable (Supplied) Notes • When removing Flash Memory, pull it out straight. • If sound is not output or Flash Memory is not recognized even when Flash Memory is connected, remove Flash Memory once, then connect it again. 48-EN