Amana AGP200VDW Installation Instruction - Page 17
Complete Conversion, Pilot and By-pass Screws Conversion
UPC - 883049214153
View all Amana AGP200VDW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 17 highlights
Pilot and By-pass Screws Conversion 1. Remove control knobs and set aside. 2. Remove upper grates. 3. Lift the cooktop by both front corners and hold it by the front center edge. 4. Open oven door. 5. Locate the two top fasteners and two bottom fasteners on the front panel and remove them, using a Phillips head screwdriver. A A. Top fasteners B. Bottom fasteners B 6. Set the front panel aside and locate the oven thermostat. 13. Replace the front panel and screw bottom and top fasteners in place. 14. Slowly lower the cooktop until it snaps into position. Close the oven door. Complete Conversion 1. Refer to the "Make Gas Connection" section for properly connecting the range to the gas supply. 2. Turn the manual shutoff valve in the gas supply line to the open position. 3. Refer to the "Check Operation" section for proper burner ignition, operation, and burner flame adjustments. IMPORTANT: You may have to adjust the "LO" setting for each cooktop burner. Checking for proper cooktop and oven burner flames is very important. The small inner cone should have a very distinct blue flame 1/4" to 1/2" (6.4 mm to 13 mm long). The outer cone is not as distinct as the inner cone. Natural gas flames do not have yellow tips. 4. Close the broiler door and press the "OFF" pad. 5. Refer to the "Complete Installation" section to complete this procedure. A A. Oven thermostat 7. Locate the natural gas by-pass screw in the bag containing literature included with the range. One natural gas by-pass screw is stamped "76". 8. Remove the LP gas by-pass screw with a flat blade screwdriver, turning counterclockwise. A B A. Pilot screw B. By-pass screw 9. Install the natural gas by-pass screw with a flat blade screwdriver turning, clockwise. 10. Locate the natural gas pilot screw in the bag containing literature included with the range. One natural gas pilot screw is stamped "94". 11. Remove the LP gas pilot screw with a flat blade screwdriver, turning counterclockwise. 12. Install the natural gas pilot screw with a flat blade screwdriver, turning clockwise. 17