Ariens Pro Track 28 Owners Manual - Page 10

9. Connect the chute lock cable to the lock arm by fitting the cable ball end into the slot on the lock arm and then insert the chute lock cable fitting into the bracket on the chute pedestal (Figure 8). 10. Adjust and tighten jam nuts on cable to remove cable slack. Be sure not to pretension lock arm so it retracts from the gear teeth see Discharge Chute Control on page 25. Figure 8 OS7271 11. Replace the gear cover removed in step 4. 12. Orient the chute and pedestal to its most vertical position and tighten pedestal hardware to 15 - 31 lbf-ft (20 - 42 N•m). 13. Make sure the discharge chute rotates left and right when you push the discharge chute control lever left and right. NOTE: If chute does not stay in position, adjust as directed in Discharge Chute Control on page 25, or repair before operation. Remote Deflector Control (Figure 9) Connect the cable end to the cable anchor on the discharge deflector before clipping the cable to the cable bracket on the discharge chute. 1. Route deflector remote cable along the left side of the chute pedestal. 2. Insert the barrel on the cable end into the bracket on left side of chute deflector (Figure 9). 3. Hold seal out of the way while routing the cable through the bracket on the left side of the discharge chute, and then push the cable fitting into the bracket. 4. Push the seal securely over the end of the cable fitting to prevent water from entering the cable. Check deflector travel. Adjust nut on cable end under handlebar to obtain full travel, if necessary (see Remote Deflector Control on page 25). 2 3 1 3 5 4 1. Cable Anchor 2. Cable End 3. Deflector Cable 4. Cable Fitting 5. Cable Bracket Figure 9 OS7070 Connect Battery (926104, 105) 1. Remove wing nuts from battery cover. 2. Install wire lead to battery terminal. 3. Install battery cover and tighten wing nuts. GB - 10