Asus K8N-DL User Guide - Page 49
Chassis Signal
View all Asus K8N-DL manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
12. Chassis intrusion connector (4-1 pin CHASSIS1) This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event. By default, the pins labeled "Chassis Signal" and "Ground" are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature. CHASSIS1 ® K8N-DL (Default) K8N-DL Chassis intrusion connector 13. Front panel audio connector (10-1 pin FP_AUDIO1) This connector is for a chassis-mounted front panel audio I/O module that supports legacy AC '97 audio standard. Connect one end of the front panel audio I/O module cable to this connector. +5VSB_MB Chassis Signal GND ® K8N-DL FP_AUDIO1 MIC2 MICPWR Line out_R NC Line out_L AGND +5VA BLINE_OUT_R BLINE_OUT_L K8N-DL Front panel audio connector ASUS K8N-DL 2-29