Bowflex Xtreme 2 SE Assembly Manual - Page 18

Assembly Guide Step 15 Install Upper Lat Tower Assembly, Ab Crunch Station and Lat Pulley Parts: • Upper Lat Tower Assembly • Ab Crunch Station • Lat Pulley Housing • Main Assembly Hardware: • 5 Button Head Screws (3/8" X 3/4") • 5 Flat Washers (3/8") Tool: 7/32" Hex Wrench Figure 15a 15-1 S lide the Upper Lat Tower Assembly onto the Lower Lat Tower as shown. 15-2 Place the Ab Crunch Bracket against back of the Lat Tower Assembly. Align the bolt holes on the Ab Crunch Bracket's side flaps with the lower bolt holes on the sides of the Lat Tower. 15-3 To attach the Ab Crunch Station to the Lat Tower, install a 3/4" screw and washer through the upper bolt hole on the Ab Crunch Station into the back of the Lat Tower as shown in Detail 15a. Secure the Ab Crunch Station to the sides of the Lat Tower with 2 screws and washers as shown in Detail 15a. 15-4 R emove the plastic cap from the end of the the long bolt already installed in the back of the Lat Pulley/ Housing. Finger tighten the bolt-it will be removed and reinstalled during Step 17 and 18. 15-5 Position the Lat Pulley Housing bracket against the Lat Tower, over the Ab Crunch Station. Align the bolt holes as shown in Figure 15b. 15-6 Place one washer over the end of each screw. Attach the Lat Pulley Housing to the Lat Tower by installing the screws loosely into the aligned holes as shown in Figure 15b. Do not tighten hardware at this time. Detail 15a Figure 15b Ab Bracket on Lat Tower 14 Bowflex Xtreme® 2 SE Assembly Manual Flat Washer Button Head Screw Lat Pulley Housing Washer Long Bolt