Bowflex Xtreme 2 SE Assembly Manual - Page 21

Assembly Guide 2 2 1 1 Step 18 Cable and Pulley Routing - Connect Pulleys and Cables to the Lat Pulley Housing Locate the following items for the Lat Pulley Housing assembly: • (2) Pulleys from step 17 • 3/8" X 4 1/2" Hex Head Bolt - uninstalled in Step 17 • 3/8" Washer - uninstalled in Step 17 Note:Connecting the Cables is much easier with a second persn assisting you. 18-1 H olding both Cables from Step 17 in place, align the 2 Lat Pulleys as shown in Figure 18. Slide the Pulleys back into the Lat Pulley Housing, lining up the bolt holes in the Pulleys and Lat Pulley Housing. 18-2 P lace the Washer over the 4 1/2" Bolt from Step 17. Slide the Bolt through the aligned holes in the Lat Pulley Housing and Lat Pulleys as shown in Figure 18. Tighten all hardware. Note: Y ou will probably need to push the Power Rod® unit out of the way for this step. The Power Rod® unit is not pictured for the sake of clarity. Bowflex Xtreme® 2 SE Assembly Manual 17