Brother International BAS-342G Basic Instruction Manual - English - Page 28

Threading the upper thread, end of the thread.

Get Brother International BAS-342G PDF manuals and user guides View all Brother International BAS-342G manuals
Add to My Manuals
Save this manual to your list of manuals

Page 28 highlights

5. PREPARATION BEFORE SEWING 5-3. Threading the upper thread Thread the upper thread correctly as shown in the illustration below. * When using threading mode for threading, the tension discs (1) will open so that the thread can be threaded more easily. (Refer to following page.) 3994M [If using cotton thread or spun thread] [If using synthetic thread] Thread the upper thread Needle cooler 3993M 3995M • Turn the machine pulley (2) and raise the thread take-up (3) to its highest position before threading the upper thread. (This will make threading easier and it will prevent the thread from coming out at the sewing start.) • When threading the thread through the needle, allow a distance of approximately 42 mm between the needle hole and the end of the thread. If the trailing length of the thread is too long, it may cause the thread to become tangled. 20 BAS-342G

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
5. PREPARATION BEFORE SEWING
20
BAS-342G
5-3. Threading the upper thread
Thread the upper thread correctly as shown in the illustration below.
* When using threading mode for threading, the tension discs (1) will open so that the thread can be threaded more easily.
(Refer to following page.)
•
Turn the machine pulley (2) and raise the thread take-up (3) to its highest position before threading the upper thread.
(This will make threading easier and it will prevent the thread from coming out at the sewing start.)
•
When threading the thread through the needle, allow a distance of approximately 42 mm between the needle hole and the
end of the thread.
If the trailing length of the thread is too long, it may cause the thread to become tangled.
[If using cotton thread or spun thread]
3993M
3994M
3995M
[If using synthetic thread]
Thread the upper thread
Needle cooler