Brother International BE-1204B Instruction Manual - English - Page 259
Put the thread through the thread guide [3].
View all Brother International BE-1204B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 259 highlights
! Winding lower thread Chapter 13 Connection and Installation of Optional Equipment [3] [5] [6] [8] [4] [7] [3] [2] [1] [9] W1328Q 1. Turn the power switch on. 2. Set the bobbin [1] in the bobbin winder shaft [2]. 3. Put the thread through the thread guide [3]. 4. Wind the thread around the bobbin [1] several times in the direction of the arrow. 5. Press the bobbin hold [4]. If the thread cannot be wound evenly, loosen the screw [5] and move the thread guide [3] right and left for adjustment. In order to wind more threads around the bobbin, loosen the thread [6] and move the bobbin hold [4]. 6. After winding is finished, pull out the bobbin from the bobbin winder shaft and trim the thread using the thread trimmer [7]. • If the thread is wound too tight and comes off from the tension disk, loosen the knob [8]. If the thread is too loose, tighten the knob [8]. • If the circuit protector [9] functions, the bobbin winder motor does not rotate. Leave it for a while for cooling. Then press the circuit protector [9]. (The thread does not come out when the motor is not cooled enough.) BE-1204B-BC • BE-1206B-BC 13-3