Brother International BE-1204B Cap Frame Device Instruction Manual - English - Page 12

Attaching the wide cap frame device / semiwide cap frame, device, CAUTION

Get Brother International BE-1204B PDF manuals and user guides View all Brother International BE-1204B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 12 highlights

Attaching the wide cap frame device / semiwide cap frame device 注意/CAUTION Turn off the power switch before starting any cleaning work, otherwise the machine may operate if the start switch is pressed by mistake, which could result in injury. Use only the proper replacement parts as specified by Brother. Any problems in machine operation which result from unauthorized modifications to the machine will not be covered by the warranty. Attaching the wide cap frame /semiwide cap frame driving part [9] [10] [1] [3] [9] [4] W1422Q 1. ベッド[4 C クミ[3 1. Pass the driver C assembly [3] through the bed [4]. [8] W1424Q 2 N[8 X 1 9 2. Put the cap frame sash N [8] so that the positioning pins [9] of the X-feed sash [1] fit into the inside oval holes of the sash. 10 Electronic embroidery machine

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
10
Electronic embroidery machine
ワイド帽子枠
/
セミワイド帽子枠の取り付け方法
Attaching the wide cap frame device / semiwide cap frame
device
注意
注意
注意
注意
/CAUTION
装置を取付ける場合には電源スイッチを切
り、電源プラグを抜いてください。
誤ってスタートスイッチを押すと、ミシンが
作動してけがの原因となります。
部品は当社指定の交換部品を使用してくださ
い。
ミシンを改造して起きた損害等に対しては、
保証の対象外となります。
Turn off the power switch before starting any
cleaning work, otherwise the machine may
operate if the start switch is pressed by mistake,
which could result in injury.
Use only the proper replacement parts as
specified by Brother.
Any problems in machine operation which result
from unauthorized modifications to the machine
will not be covered by the warranty.
ワイド帽子枠
/
セミワイド帽子枠駆動部の取り付け
/
Attaching the wide cap frame /semiwide cap frame driving part
W1422Q
W1424Q
1.
ベッド
[4]
にドライバー
C
クミ
[3]
を通します。
1.
Pass the driver C assembly [3] through the bed [4].
2.
ボウシワクサッシ
N[8]
の内側の小判穴を
X
オクリサッシ
[1]
の位置決めピン
[9]
に合わせ、載せ
ます。
2.
Put the cap frame sash N [8] so that the positioning pins [9] of the X-feed sash [1] fit into the inside
oval holes of the sash.
[3]
[4]
[10]
[9]
[1]
[9]
[8]