Brother International BE-1204B Cap Frame Device Instruction Manual - English - Page 13

Open the two fixed levers [6] in the direction of the arrow to shift them outside, then put

Get Brother International BE-1204B PDF manuals and user guides View all Brother International BE-1204B manuals
Add to My Manuals
Save this manual to your list of manuals

Page 13 highlights

[3] [5] [2] [7] [6] W1423Q 3. Y 2 C クミ[3 5 3. Put the positioning pins [5] of the driver C assembly [3] into the oval holes from the reverse side of the Y-feed sash [2]. 4. 2 6 7]を Y 2 4. Open the two fixed levers [6] in the direction of the arrow to shift them outside, then put the fixing pins [7] into the gourd-shaped holes of the Y-feed sash [2]. 5 6 7 6 5. Keep the fixed levers [6] open and shift the fixing pins [7] up to the inside limit, then turn the fixed levers [6] down to fix them. 6 10 N[8]を X 1 6. Fix the cap frame sash N [8] with the thumb screw [10] on the X-feed sash [1]. After the setting of the cap frame, adjust the sash position to align it with the cap center. Electronic embroidery machine 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
Electronic embroidery machine
11
W1423Q
3.
Y
オクリサッシ
[2]
の裏側から、ドライバー
C
クミ
[3]
の位置決めピン
[5]
を小判穴に差し込みま
す。
3.
Put the positioning pins [5] of the driver C assembly [3] into the oval holes from the reverse side of
the Y-feed sash [2].
4.
2
本のコテイレバー
[6]
を矢印方向に開いて外側にずらし、コテイピン
[7]
を
Y
オクリサッシ
[2]
のダルマ穴に差し込みます。
4.
Open the two fixed levers [6] in the direction of the arrow to shift them outside, then put the fixing
pins [7] into the gourd-shaped holes of the Y-feed sash [2].
5.
コテイレバー
[6]
を開いたままコテイピン
[7]
を内側に一杯までずらし、コテイレバー
[6]
を下側
に倒して固定します。
5.
Keep the fixed levers [6] open and shift the fixing pins [7] up to the inside limit, then turn the fixed
levers [6] down to fix them.
6.
ツマミネジ
[10]
でボウシワクサッシ
N[8]
を
X
オクリサッシ
[1]
に固定します。
左右位置は、帽子枠をセットした後から帽子のセンターを合わせて位置決めします。
6.
Fix the cap frame sash N [8] with the thumb screw [10] on the X-feed sash [1].
After the setting of the cap frame, adjust the sash position to align it with the cap center.
[3]
[5]
[2]
[7]
[6]