Brother International BE-1204B Cap Frame Device Instruction Manual - English - Page 17

4 3 0.5～1.0mm 2 4. Hold up the driving ring [3], and fasten the screw [2] at the position where the clearance between the ring and the needle plate is about 0.5 to 1.0 mm. 5 3 2 5 A[8 6 1 5. If the clearance is still insufficient with the driving ring held up, fasten the screw [2] at the position and hold up the cap frame driver. At the position which the enough clearance is assured, adjust the sliding sheet [5] to touch the upper surface of the bed cover A [8], then fasten the driver support plate [6] with the screw [1]. [7] [8] [5] [6] W1429Q 注意) X N[7 6 Note) Move the X-feed sash right and left to confirm that the cap frame sash N [7] and the driver support plate [6] do not interfere each other. Also confirm that they do not interfere the next cap frame driver. Electronic embroidery machine 15