Brother International BE-1204B Instruction Manual - English - Page 245
Presser foot down error, If the cable is - bc ca
View all Brother International BE-1204B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
Chapter 11 Error code list Code E-B2 E-B3 E-B4 E-B5 E-B6 E-B7 E-B8 Error Hook motor home position error Hook motor standby position error Hook motor motor mode error Hook motor communication error Hook motor parameter error Hook motor overheat error Hook motor overcurrent error E-B9 Thread trimming motor zero point error E-BA Power supply frequency error E-BC No power error E-BD E-BE E-BB, BF E-C1 Lower shaft flash memory error Lower shaft version-up error Lower shaft motor undefined error Area over during embroidering Measures This is not displayed in this model. Turn the power off and on once. If the same error occurs again, the lower shaft motor is faulty. Turn the power off and check the thread trimmer and turn the power on again. If it occurs again, the thread trimmer is faulty. It may usually occur momentarily when turning off the machine. If it occurs when the machine is on, it is a power failure detection error. This is not displayed in this model. E-C2 Wiper out error E-C3 Embroidering data buffer empty E-C4 E-C5 E-C6 E-C7 E-C8 E-C9 E-CA Presser foot down error Measured voltage value could not be received form the lower shaft motor CPU. Voltage value could not be transferred to the lower shaft motor CPU. Lower shaft error Hook motor home position error Embroidering start error No sewing permisson If the wiper is tangled with a thread, remove it. Press the or turn on the F/B switch on the head to either side. Check the connection of the communication cable of the panel. If the cable is connected correctly , press the or turn on the F/B switch on the head to either side. If the cable is disconnected , turn off the power and connect the cable. This is not displayed in this model. E-CB E-CC E-CD E-CE E-CF E-D0 E-D1 Spindle rotation speed error Shuttle thread entanglement automatic reset Speed command can not be received. Cylinder bed position error Rated voltage value could not be received from the lower shaft motor CPU. Power PC board error Cooling fan motor stop. Press the or turn on the F/B switch on the head to either side to cancel the error and press the . If the same error occurs again, there is a possibility that the spindle is overloaded. This is not usually displayed. Turn the power off and on once. If the same error occurs again, the main PCB is faulty. This is not usually displayed. Turn the power off and on once. If the same error occurs again, the power PCB is faulty. This is not usually displayed. BE-1204B-BC • BE-1206B-BC 11-5