Brother International BE-1204B Instruction Manual - English - Page 36
For embroidering with tubular square hoop or cap frame lower position
View all Brother International BE-1204B manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Chapter 2 Preparation of Embroidery Machine ! For embroidering with tubular square hoop or cap frame (lower position) [7] [6] [4] [6] [8] [5] [3] [2] [1] [5] W1227Q 1. Attach four hexagon socket head cap screws to each of table parts R [1], M [2](BE-1206B and BE-1204C only), and L [3] from the back. 2. Put the table backing plate [4] of each table on to the table guide bridge [5], and slide to the other side. Insert the table backing plate [4] into the table backing rubber on the table support Rear [6]. 3. Adjust table supports front [7] in height so as to make the table parallel with the floor. 4. Tighten all hexagon socket head cap screws [8] firmly. 2-8 BE-1204B-BC • BE-1204C-BC • BE-1206B-BC
2-8
BE-1204B-BC ° BE-1204C-BC ° BE-1206B-BC
Chapter 2 Preparation of Embroidery Machine
!
For embroidering with tubular square hoop or cap frame (lower position)
W1227Q
1.
Attach four hexagon socket head cap screws to each of table parts R [1], M [2](BE-1206B and
BE-1204C only), and L [3] from the back.
2.
Put the table backing plate [4] of each table on to the table guide bridge [5], and slide to the other
side. Insert the table backing plate [4] into the table backing rubber on the table support Rear [6].
3.
Adjust table supports front [7] in height so as to make the table parallel with the floor.
4.
Tighten all hexagon socket head cap screws [8] firmly.
[1]
[2]
[3]
[8]
[7]
[6]
[4]
[6]
[5]
[5]