Brother International BE-1204B Instruction Manual - English - Page 46

Chapter 2 Preparation of Embroidery Machine 1. Pass an upper thread from the cotton stand through the hole of the thread guide right above each cotton stand bar. Pass the thread from the back to the front hole. The cotton stand (top view) Pass a thread in the order indicated in the figure. Front W1234Q 2. Pass the thread through the upper hole of the pretension [1]. Push up the thread guide tension disc with your finger, and pass it from the left to the lower hole. 3. Pass the thread through the upper hole of the 2nd pretension. Push up the thread guide tension disc[2] with your finger, and pass it from the left to the lower hole. 4. Wind the thread clockwise once around the rotary disc and place it on the spring. 5. Pass the thread through the hole of tension stand inner thread guide [3]. 6. After passing the thread through the hole of tension stand lower thread guide [4], insert the thread into the right side of the inner thread guide and pass it through the hole of the thread take-up. 7. Bring the thread back to the inner thread guide. Insert the thread into the hole from the upper section. 8. Pass the thread through the hole of the wire of the needle bar thread guide [6] and pass it through the needle eye. Pass it through the presser foot. Pass it to presser spring at the front of lower thread guide [5]. 2-18 BE-1204B-BC • BE-1206B-BC