Brother International Innov-is 500D Users Manual - English - Page 110
mm 1/16 inch in front of the pocket
View all Brother International Innov-is 500D manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
SE-BrotherE_sgml.book Page 104 Monday, June 30, 2003 3:44 PM UTILITY STITCHES Attach buttonhole foot "A". b • For details, refer to "Replacing the presser foot" (page 40). Select stitch 54 . c Pull down the buttonhole lever as far as e possible. • For details, refer to "Selecting stitching" (page 47). Position the fabric so that the opening of the d pocket faces toward you, and then lower the presser foot lever so that the needle drops 2 mm (1/16 inch) in front of the pocket opening. 1 1 a Buttonhole lever The buttonhole lever is positioned behind the bracket on the buttonhole foot. 1 2 a Buttonhole lever b Bracket Gently hold the end of the upper thread in f your left hand, and then start sewing. a 2 mm (1/16 inch) Pass the upper thread down through the hole in the presser foot. • When lowering the presser foot, do not push in the front of the presser foot, otherwise the bar tack will not be sewn with the correct size. X Once sewing is completed, the machine automatically sews reinforcement stitches, then stops. Raise the presser foot lever, remove the fabric, g and then cut the threads. Raise the buttonhole lever to its original h position. 1 a Do not reduce the gap. Memo z If the fabric does not feed, for example, because it is too thick, increase the stitch length. For details, refer to "Adjusting the stitch length" (page 57). 104