Brother International LK3-B431 MKII Instruction Manual - Page 20
Acaution
View all Brother International LK3-B431 MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
3. INSTALLATION 3-11 . Installing the operation panel The operation panel can be installed to either the top or bottom of the work table. Top of work table Bottom of work table 3 O Op Cla 2:3 00 5 5 Table 3 Op Table 1. Install the rear frame 0 to the work table (top or bottom) with the four wood screws 0. 2. Install the front frame 0 to the rear frame 0 with the four screws 0. * The vertical orientation of the front frame 0 is the same whether it is installed to the top or the bottom of the work table. 3. Insert the connector cord 0 into the control box through the hole at the side of the box. Refer to "3-13. Connecting the cords" for details on connecting the cord. 4. Secure the connector cord 0 with the staples (in three places). 3-12 . Connecting the ground wire A CAUTION Be sure to connect the ground. If the ground connection is not secure, you run the risk of receiving a serious electric shock, and problems with correct operation may also occur. 0 Red 0 White 0 Black 0 Yellow/Green Connect to the power switch. However, the black wire is insulated to the inside of the box and is not used. Connect to ground 13 LK3-6430E-, B431E-, B432E-, B433E- Mark II