Brother International LK3-B431 MKII Instruction Manual - Page 35

8. SEWING 8. SEWING A CAUTION Turn off the power switch at the following times, otherwise the machine may operate if the foot switch is depressed by mistake, which could result in injury. • Threading • When replacing the needle • When not using the machine and when leaving the machine unattended. • Do not touch any of the moving parts or press any objects against the machine while sewing, as this may result in personal injury or damage to the machine. Before starting sewing Check that the needle bar is at its highest position. Turn the machine pulley so that the index mark 0 on the pulley is between the marks 0 on the belt cover. * If the machine pulley stop position is incorrect, error "E-50" may be displayed, or the wiper may come into contact with the needle and break the tip of the needle. 1. Turn on the power switch. (The POWER indicator will illuminate and the program number will flash in the display.) 2. Depress the foot switch to the 2nd step. 1st Step 4_ The feed mechanism will move to the starting 2nd Step position and the work clamp 0 will rise. 0 * Note that if the foot switch is pressed to the 2nd step while the display is illuminated, the machine will start operating. 3. Place the material to be sewn under the work clamp 0, and then depress the foot switch. When the foot switch is pressed to the 1st step, the work clamp 0 will lower. If you would like to shift the position of the material, release the foot switch. The work clamp 0 will then rise again. When the foot switch is pressed to the 2nd step, the machine will start operating. 4. Once sewing is completed and the thread has been trimmed, the work clamp 0 will rise. LK3-6430E-, B431E-, B432E-, B433E- Mark II 28