Brother International LK3-B431 MKII Instruction Manual - Page 44
clamp, pressure, adjustmentB432E
View all Brother International LK3-B431 MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
10 . STANDARD ADJUSTMENTS [B432E Mark II] The maximum work clamp lift amount is 17 mm from the top of the needle plate when the machine is stopped. The lift amount is adjusted 13'a mm at the time of shipment. O O O 0 0 7mm While the machine is stopped, loosen the bolt 0 and move the presser roller attachment plate 0 vertically to adjust the lift amount. * When making this adjustment, check to see if the work clamp will open. Also, readjust the closing distance of the work clamp according to the second procedure of "10-10. Work clamp closing-distance adjustment". * If the work clamp cannot be raised or lowered, error code "E-61" or "E-63" will be displayed. 10-9.Work clamp pressure adjustment(B432E Mark II) Loosen the lower adjusting ring 0 as much as possible (to the extent that the material being sewn does not slip and alter the pattern). Then, adjust the pressure by turning the upper adjusting ring 0. 0 ■ Removal of the work clamp spring.... Lower the work clamp, then place the adjusting ring O 0 in the hole of the frame, remove the tip of the adjusting screw from the lever holder 0, and re- move the work clamp spring 0. 37 LK3-8430E-, 8431E-, 8432E-, 8433E- Mark II