Brother International LK3-B431 MKII Instruction Manual - Page 56
used. Only
View all Brother International LK3-B431 MKII manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
13. CHANGING SPECIAL FUNCTIONS USING THE MEMORY SWITCHES • Memory switches 10 -1F Switch memo-10 memo-11 - memo-13 memo-14 memo-15 memo-16 memo-17 memo-18 memo-19 memo-1A Motion when set to ON The optional emergency stop switch can be used. - Solenoid wiper can be used (available as an option). - Needle cooler output is enabled. (Needle cooler is available by special order.) Thread take-up device is not operated at the sewing end. Thread take-up device operates one stitch before the sewing end. Presser position errors are not detected. Needle up stop position errors are not detected. memo-1b Presser can be moved up and down before the home position is detected. (Normally the presser cannot be moved up and down until after the home position has been detected.) memo-1c memo-1d memo-1E - - Errors can be reset using the EMERGENCY STOP switch. (EMERGENCY STOP switch is available as an option.) memo 1F Thread is not trimmed when an emergency stop occurs during sewing. (EMERGENCY STOP switch is available as an option.) • Memory switches 20 - 2F Switch memo-20 memo-21 memo-22 Motion when set to ON Machine head from previous B430E series is used. (Only the operation panel and box are Mark II.) Rotating-type thread breakage detector operates. (Device is available by special order.) During thread breakage detection, sensitivity is decreased from 8 to 14 stitches at the sewing start. (Sensitivity during sewing is three stitches.) memo-23 memo-24 - memo-2F When DIP switch A-8 is simultaneously ON, setting values changed using the operation panel are ignored. - • Memory switches 30 - 4F 30 to 4F are set by entering two-digit values. These values are incremented using the P2 switch, and decremented using the P4 switch. Switch Possible setting range Units Initial value Explanation memo-30 0 - 30 mm Ellillal:30 CI:12 Limits the maximum area in the horizontal direction (X) memo-31 memo-32 memo-33 memo-34 memo-35 memo-36 memo-37 memo-38 memo-39 memo-3A memo-3b memo-3c memo-3d memo-3E memo-3F memo-40 memo-4F 0 - 30 ODE 12 - 27 WI 12 - 25 1 - 10 0 - 5 3 - 9 - 1 - 20 1 - 20 1 - 20 1 - 20 1 - 20 - - - - mm x 100rpm x 100rpm x 7.5° Needle x 100rpm - x 7.5' x 7.5° x 7.5° x 7.5° x 7.5° - - - - DC:3la,©.i:1:300 Limits the maximum area in the vertical direction (Y) 27 - Changes the maximum sewing speed. 25 5 Changes the feed timing 1 (Fast)