Canon DIGISUPER 80 manual for XJ100x9.3B AF XJ100x9.3B XJ95x12.4B XJ95x8.6B XJ - Page 45
Mounting the, Accessories for Full, Servo Operation
View all Canon DIGISUPER 80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
1 HOW TO MOUNT 1-2 Mounting the Accessories for Full Servo Operation The servo demand is mounted and connected as shown in the figure below. When mounting the various demands, refer to the operation manual for the respective demand. Bottom compartment of the lens Coupling B Arrow A Key Groove Key Pin Index Line (White Line) Lock Axis Coupling A Lock Screw Servo Module 3 Mate the coupling A of the module with the coupling B of the lens. And then, fully push the module in the direction of arrow "B" until it stops. 4 Finally, turn the lock screw of the module clockwise to secure it. By using a coin, tighten firmly the lock knob. ᶃ Servo module ᶄ Zoom servo demand ᶅ Focus servo demand ᶆ Demand cable Arrow B Lock Mounting the Servo Module onto the Lens It is necessary to mount the servo module to the zoom and focus couplings located in the bottom compartment of the lens. * (NOTE) The same servo module is used for both zoom and focus couplings. So, it can be mounted on either the zoom or focus coupling. 1 Before mounting a module to the lens, turn the lock screw of the module counterclockwise until the lock axis comes out to its a half way of length. 2 Press the module in the direction of arrow "A", so that the key pins on the lens are inserted in the key grooves of the module. Lock Screw Next, as the same procedure, install the servo module on the other joint. It does not matter which is installed first, either the zoom or the focus. * (NOTE) When mating couplings A and B, push the servo module in completely, so that the index line (white line) on the circumference of coupling B is entirely hidden. If index line is not completely hidden, the servo module may fail to operate, or it may generate abnormal acoustic noise. Mounting the Switch Box 1 Mount the switch box to the panhandle of the tripod, using the attached clamp. 2 Connect the switch box to the lens, using the included cable. E3