Cisco WS-C4003 Software Guide - Page 209
Configuration Guidelines, Configuring Dynamic Port VLAN Membership with Auxiliary VLANs
View all Cisco WS-C4003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 209 highlights
Chapter 12 Configuring Dynamic Port VLAN Membership with VMPS Dynamic Port VLAN Membership with Auxiliary VLANs Note For detailed information on auxiliary VLANs and Cisco voice-over-IP networks, refer to the "Configuring a Voice-over-IP Network" chapter in the Catalyst 6000 Family Software Configuration Guide. Configuration Guidelines These guidelines and restrictions apply to configuring dynamic port VLAN membership for auxiliary VLANs: • Configuration of the native VLAN ID is dynamic for the PC connected to the access port of the IP phone. Configuration of the auxiliary VLAN ID is not dynamic, you need to configure it manually. As you manually configure the auxiliary VLAN ID, the VMPS server is queried for packets coming from the PC, but not for packets coming from the IP phone. • All packets except CDP packets from the IP phone are tagged with the auxiliary VLAN ID. All such tagged packets are considered to be packets from the phone, and all other packets are considered to be packets from the PC. • When configuring the auxiliary VLAN ID with untagged frames, you need to configure the VMPS server with the IP phone's MAC address (see the "Dynamic Port VLAN Membership with VMPS Configuration Examples" section on page 12-7 for information on configuring VMPS). • For dynamic ports, the auxiliary VLAN ID cannot be the same as the native VLAN ID assigned by VMPS for the dynamic port. • Read the "Dynamic Port VLAN Membership and VMPS Configuration Guidelines" section on page 12-3 prior to doing any port configuration. Configuring Dynamic Port VLAN Membership with Auxiliary VLANs This example shows how to add voice ports to auxiliary VLANs and specify an encapsulation type: Console> (enable) set port auxiliaryvlan 5/9 222 Auxiliaryvlan 222 configuration successful. AuxiliaryVlan AuxVlanStatus Mod/Ports 222 active 5/9 Console> (enable) Console> (enable) set port auxiliaryvlan 5/9 untagged Port 2/48 allows the connected device send and receive untagged packets and without 802.1p priority. Console> (enable) This example shows how to specify port 5/9 as a dynamic port: Console> (enable) set port membership 5/9 dynamic Warning: Auxiliary Vlan set to dot1p|untagged on dynamic port. VMPS will be queried for IP phones. Port 5/9 vlan assignment set to dynamic. Spantree port fast start option enabled for ports 5/9. Console> (enable) 78-12647-02 Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 12-11