Cisco WS-C4003 Software Guide - Page 399

Chapter 27 Configuring Switch Access Using AAA Configuring Authentication Resetting the 802.1x Configuration Parameters to the Default Values You can reset the 802.1x configuration parameters to the default values with a single command, which also globally disables 802.1x. To reset the 802.1x configuration parameters to the default values, perform this task in privileged mode: Step 1 Step 2 Task Command Reset the 802.1x configuration parameters to the clear dot1x config default values and globally disable 802.1x. Verify the 802.1x configuration. show dot1x This example shows how to reset the 802.1x configuration parameters to the default values and verify the configuration: Console> (enable) clear dot1x config This command will disable dot1x on all ports and take dot1x parameter values back to factory defaults. Do you want to continue (y/n) [n]? Console> (enable) show dot1x PAE Capability Authenticator Only Protocol Version 1 system-auth-control enabled max-req 2 quiet-period 60 seconds re-authperiod 3600 seconds server-timeout 30 seconds supp-timeout 30 seconds tx-period 30 seconds Setting the Trace Severity You can alter the trace severity for 802.1x authentication with this command. The number setting affects the number of trace messages displayed. Low numbers result in fewer messages; high numbers result in more messages. To set the trace severity for 802.1x, perform this task in privileged mode: Task Command Set the trace severity for 802.1x authentication. set trace dot1x trace-level This example shows how to set the trace severity for 802.1x authentication to 5: Console> (enable) set trace dot1x 5 DOT1X tracing set to 5 Warning!! Turning on trace may affect the operation of the system. Use with caution. 78-12647-02 Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 27-45