Cisco WS-C4003 Software Guide - Page 54
Configuring the SLIP (sl0) Interface on the Console Port
View all Cisco WS-C4003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 54 highlights
Configuring the SLIP (sl0) Interface on the Console Port Chapter 3 Configuring the Switch IP Address and Default Gateway enabled enabled enabled The primary gateway: 10.1.1.1 Destination Gateway default 10.1.1.1 default 10.1.1.20 default 10.1.1.10 10.0.0.0 10.1.1.100 default default Console> (enable) RouteMask ---------0x0 0x0 0x0 0xff000000 0xff000000 Flags ----UG G G U UH Use -------6 0 0 75 0 Interface --------- sc0 sc0 sc0 sc0 sl0 This example shows how to configure two default gateways on a Catalyst 4000 family, Catalyst 2948G, or Catalyst 2980G switch, with one default gateway reachable through the sc0 interface and one reachable through the me1 interface: Console> (enable) show interface sl0: flags=50 slip 0.0.0.0 dest 0.0.0.0 sc0: flags=63 vlan 5 inet 172.20.52.38 netmask 255.255.255.240 broadcast 172.20.52.47 me1: flags=63 inet 10.1.1.100 netmask 255.255.255.0 broadcast 10.1.1.255 Console> (enable) set ip route default 172.20.52.33 Route added. Console> (enable) set ip route default 10.1.1.1 Route added. Console> (enable) show ip route Fragmentation Redirect Unreachable enabled enabled enabled The primary gateway: 172.20.52.33 Destination Gateway RouteMask default 10.1.1.1 0x0 default 172.20.52.33 0x0 172.20.52.32 4000-2 0xfffffff0 10.1.1.0 10.1.1.100 0xffffff00 Console> (enable) Flags ----G UG U U Use -------0 12 180 22 Interface --------- me1 sc0 sc0 me1 Configuring the SLIP (sl0) Interface on the Console Port Use the SLIP (sl0) interface for point-to-point SLIP connections between the switch and an IP host. Caution You must use the console port for the SLIP connection. When the SLIP connection is enabled and SLIP is attached on the console port, an EIA/TIA-232 terminal cannot connect through the console port. If you are connected to the switch CLI through the console port and you enter the slip attach command, you will lose the console port connection. Use Telnet to access the switch, enter privileged mode, and enter the slip detach command to restore the console port connection. Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 3-8 78-12647-02