Cisco WS-C4003 Software Guide - Page 349
Scheduling a Reset Within a Specified Amount of Time, Power Management
View all Cisco WS-C4003 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 349 highlights
Chapter 26 Administering the Switch Power Management Reset scheduled for 23:00:00, Sat Aug 18 2001 (in 0 day 8 hours 39 minutes). Console> (enable) This example shows how to schedule a reset with a minimum of downtime: Console> (enable) reset mindown at 23:00 08/18 Software upgrade to 6.3(1) Reset scheduled at 23:00:00, Sat Aug 18 2001. Reset reason: Software upgrade to 6.3(1). Proceed with scheduled reset? (y/n) [n]? y Reset mindown scheduled for 23:00:00, Sat Aug 18 2001 (in 0 day 8 hours 39 minutes). Console> (enable) Scheduling a Reset Within a Specified Amount of Time You can schedule a reset within a specified time with the reset in command. For instance, if the current system time is 9:00 a.m. and the reset is scheduled to take place in one hour, the scheduled reset will take place at 10:00 a.m. If you or NTP advances the system clock to 10:00 a.m., the reset will take place at 11:00 a.m. If the clock is advanced ahead of the scheduled reset time, the reset will take place 5 minutes after the command is issued. To schedule a reset within a specified time, peform this task in privileged mode: Step 1 Step 2 Task Command Schedule the reset time within a specific amount reset [mindown] in [hh] {mm} [reason] of time. Verify that the scheduled reset time is correct. show reset Note The minimum downtime argument is valid only if the system has a redundant supervisor engine. This example shows how to schedule a reset in a specified time: Console> (enable) reset in 5:20 Configuration update Reset scheduled in 5 hours 20 minutes. Reset reason: Configuration update Proceed with scheduled reset? (y/n) [n]? y Reset scheduled for 19:56:01, Wed Aug 18 1999 (in 5 hours 20 minutes). Reset reason: Configuration update Console> (enable) Power Management This section describes power management in the Catalyst 4006 switch and includes the following major sections: • Power Redundancy, page 26-12 • Setting the Power Budget, page 26-15 The power management feature is designed to support an optimized Catalyst 4006 chassis consisting of a WS-X4013 supervisor engine and four WS-X4148-RJ or WS-X4148-RJ21 modules operating in 1+1 redundancy mode. Additional configurations are possible. 78-12647-02 Software Configuration Guide-Catalyst 4000 Family, Catalyst 2948G, Catalyst 2980G, Releases 6.3 and 6.4 26-11